Click on the image to view the original image
CM-18 High Intensity Aviation Obstruction Light type B
Use 150 meters across the Power Tower, stratified sequence flashes to show the height of the tower and the top and bottom of the hanging wires suspended height, played the role of aviation obstruction warning. |
1. The house of the light adopts SUS304 stainless steel, the structure is high strength, resistance
to corrosion
2. Use the optical design of parabolic reflector, the visual range further and angle more accurate.
3. Light source adopts high quality xenon tubes which are high brightness with light efficiency
100LM/W, low power consumption, long lifespan up to flash 100,000,000 times.
4. Based on the single chip computer control, automatic identification sync signal, do not distinguish
the main light and auxiliary light, and also could be controlled by controller.
5. Same power supply voltage with synchronous signal, integrate in power supply cable, emliminate
the damage by error installation caused.
6. Used the photosensitive probe fit for the natural ligh spectrum curce, automatic control light intensity
level.
7. The circuit of the light has surge protection whose lightning proof ability is In 7.5KA/5 times, Imax
15KA so that the light is suitable to harsh environment.
8. Integral structure, protection lever of IP65.
9. Ignitability rate UL-94V0, fit for all kinds of industrial situation.
10. GPS synchronization function is available.