Click on the image to view the original image
High quality 12V alarm police motorcycle waterproof speaker
Product Description
| Item No. | JZ11 |
| Input Voltage | 12VDC |
| Temperature Range | -20 degree C to + 65 degree C |
| Max Current | 3.5A |
| Stand by Current | 30mA |
| Power Output | 60W |
| Main Fuse | 10A |
| Feature 1 | Air Horn |
| Feature 2 | 2 Tones |
| Feature 3 | Included Mic |
| Speaker Impedance | 8 Ohm |
| Output Voltage | 17V RMS |
| Audio Response | 20Hz-10KHZz |
| Audio Power | 48W |
| Harmonic Distortion | Less than 0.1% |
| Input Impedance(PA) | more than 4000 Ohms |
| Frequency Range | 715 to 1500HZ |
| Housing | Aluminum |
| Siren Overload Protection | Siren Overload Protection Turn off for until the overload disappears then Auto Restart |
| Nominal Cycle Rate | Wail-15 cycles/min; Yelp-105 cycles/min |
Handheld System Specification:
| Operating Voltage | 12VDC |
| Temperature Range | -20 degree C to +50 degree C |
| Standby Current | 1mA |
| Number of Outputs | 2 |
| Ourput Equipments Max Current | One way out 10A; Two way out 5A |
Motorcycle Siren Mounting:
1)Place the unit against the intended mounting surface
2)Mark the areas where the mounting holes will be drilled.If the mounting surface is part of the vehicle,make sure no vital components could be damaged by the drilling process
3)Pre-drill two 1/4" mounting holes on the mounting surface,making sure no vital components of the surface are damaged
4)Make sure to deburr the holds throughly
5)Using customer provided screws, secure the Siren Amplifier to the mounting surface
Motorcycle Siren Handheld Mounting
1) Join the Switcher plastic locker on the middle of handgrip
2)Screw the controller by M5X20 bolts
60W Motorcycle Rainproof Tree-tone Oral Siren
More sirensContact us
Please contact me directly