Click on the image to view the original image
Waterproof emergency lamp kit 40W90-180 minutes/DF emergency power factory 10 years experience
This kit uses highly grade smart IC to control circuit, and offer self test, monthly test and annual test function.
DF518H50 can offer excellent working temp. management solution and specialized suit to big power flood light, high bay light,tunnel lamp and other big power led lights.
DF518H50 has IP66 solutions for outdoor lamps.
Product Description
DF518H50 emergency kit is specially designed for40-50w led lamps and make it has emergency function.
The product can match the input voltage from 90V to 280V, and the output current go through the Led driver, making LED lights 100% emergency power output when power is failure.
DF518H50 use high temperature type lithium batteries as a backup power supply. Great battery protection IC can make battery both has a good long battery life, but also has efficient energy utilization efficiency.
DF518H50 uses IC control circuit, has constant output power, isolation circuit, no-load protection feature.rgency
The installation and operation instruction
(1)—— 1: accordance with writing diagram to connect the circuit in strict. The following lines are connected to each port:
1 —— connect Live Wire L+ Connect switch line
2 —— connect the Neutral line N
3——Connect the ground wire.
4 5—— Connect light source (suit for LED light source with inside drive).
4 5—— Connect driver power, and connect light source (suit for LED light source with outside driver)
6—— Connect switch line. The other side of switch line, Enter the fire wire 1 port. Swith line and Live wire must Keep with the phase.Wall switch only control utility lighting, not affect the emergency lighting
note:
1 .This product should be installed by trained electricians. Forbid connecting wires when power is on, make power on after make sure that there is no phenomenon of short circuit and the correction is ok.
2. Main power line: Live wire TL and null line N, connect to main power line directly. no switch can be allowed when emergency lighting. the law forbids the switch control emergency circuit.
3 .The wall switch only controls the main power, no function on emergency lighting. The Switch live wire SL and charging live wire TL should be in the same phase.
4. Green light-main power ,Red light-charging , Yellow light-mulfunction;Test: test button
5.Emergency lighting condition,three-color light is all out;
6. Digital circuits, self-test function (monthly inspection, annual inspection), fault or automatic alarm function cause by illegal operation.
7 .You should connect the led lamp and charge the emergency pack before use. In order to avoid emergency lighting function failure.
8 .The environment temperature of Emergency pack ranges from minus ten degrees centigrade to 50 degrees centigrade. High-temperature aging test is forbidded.
9 .Frequently test is prohibited . Each test interval is not less than one minute.
10 .Emergency movement is the core device which controls the battery charge or discharge and start the lighting when under emergency must ensure the wiring is correct. After under normal use, need to discharge once every three months for battery conservation and extend the battery life. Emergency lighting power installed and put into use, need to regularly check, maintain, examine and repair when discover the abnormal condition, or inform the supplier to deal with.
11 .Any problem, contact the manufacturer or supplier pls.
