UL listed dimmable led puck light
DGL-CB12W
LED ACCENT KIT
120V LED Puck lights
Easy to install
cool to touch
energy saving
Long life
Lens cover is UV filter
3 LED pucks accent kit
Surface or recess mount
Warm white, 4W each puck
Linkable dimmable
50% brighter than halogen or xenon pucks
Warning & Cautions
Review important safety instructions before installation
Risk of exposure to excessive ultraviolet UV radiation
Do not operate without complete bulb enclosure in place or if lens is damaged
Prior to installation, plug your cabinet light into an available electrical outlet in order to ensure that one of more of the bulbs have not vibrated loose during shipping.
Important Safety Instructions
This light is equipped a polarized attachment plug (a plug having one blade wider than the other).
This plug will fit in a polarized outlet only one way. This is a safety feature if you are unable to insert the plug fully into the outlet, reverse the plug. If it still will not fit contact a qualified electrician.
Never use with an extension cord unless the plug can be fully inserted. Do not attempt to alter the safety purpose of the polarized plug.
Caution
To prevent electrical shock do not use this (polarized) unless the blades can be fully inserted plug with an extension cord receptacle or other outlet, unless the blades can be fully inserted.
Under cabinet only-minimum spacing 12” on centre
Lighted lamp is hot.
Bulb replacement
Use SMD LED CHIPS
12W 120V
To remove lens cover
Turn counter clockwise
Use a soft cloth when handling the bulb
To replace lens cover turn clockwise until cover is secured
Warning
To reduce the risk of fire, electric shock, exposure to excessive UV radiation or injury to persons
Turn off/unplug and allow to cool before replacing bulb
Bulb gets hot quickly! Contact only switch/plug when turning on
Do not touch hot lens, guard or enclosure
Do not remain near light if skin feels warm
Do not lock directly at lighted bulb
Keep lamp away from materials that may burn
Use only with a SMD3528 led chip
Do not touch the bulb at any time. Use a soft cloth. Oil from skin may damage bulb
Do not operate the lamp with a missing or damages lens; lens acts as guard/shield and UL light filter
This lamp is intended to be used as an under cabinet light
Avoid contact with the cord or combustibles such as plastic, paper goods, etc. With the hot bulb, bulb holder or reflector
During installation, position cabinet light with respect to the cabinet-walls, so as to permit reading for the lamp replacement marking
This cabinet light is not intended for illumination of aquariums
This cabinet light is not intended for installation in plastic cabinets
The instruction provided on the enclosed adhesive back should be attached to cabinet
injury to persons and damage to the lamp and/or mounting surface may result if the lamp is pulled from the surface.
To reduce the likelihood of such injury or damage, mount only on a wood or particle surface that is mechanically sound.
During installation, route and secure cord so as to avoid the likelihood of the cord contacting the cabinet light.
When replacing the bulb, lens cover is to be turned and removed, then follow bulb insertion and replacement directions for removing bulb.
Use only insulation staples or plastic ties to secure cord.
Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall.
Not intended for recessed installation in ceiling.
Preparation
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or operate the product.
Estimated assembly time 30 minutes
Tools required for assembly (not included)
Flathead screwdriver
Star-head Screwdriver
Drill
1/16” Drill bit
Hammer