Shenzhen EVEN Technology Co., Ltd.

Emergency Kit for LED Product

1.Model: EMI-LT

EMI-LT emergency pack is a newly designed type. It is tailor-made for LED Tubes or other driver equipped LED Lighting.

The emergency power kit equipped with the inverter, battery pack and the necessary accessories.The control circuit monitors the mains supply, if the light works as normal, the inverter allows the charger to trickle charge the battery pack in standby mode. In the event of an earthquake, explosion,accident or other emergency which results in the AC power supply to fail, the inverter automatically activates the battery backup system and switches the light on in less than 0.1 second. The system can be programmed emergency running time of 1 /2/ 3/4 hours depending on different battery packs to meet the requirements under various conditions.

2.Range of Application

-EMI-LT is applicable for 1W to 60W LED Tube Emergency lighting，Emergency output power is 1W to 60W, Emergency duration is from 0.5 to 4hours.

- EMI-LT is also applicable for any internal driver equipped led lighting,.

- Operates in -25-+70 environment temperature.

- Instruction manual

3.Product Feature

1. Intelligent automatic recharging and converting function

2. Constant current battery charger

3. 1/2/3 hours emergency operation

4. Led charge status display

5. Inverter with multiple protection functions:charge protection,discharge protection,

short circuit protection

6. Facility for a Test switch to inspect between Emergency and normal lighting function

7. Supplied with high brightness green/Red LED (manual test)

8. Complete with flex and plug

9. Push-wire terminal blocks for easy wiring installation

10. High quality of NiCD rechargeable battery with 2 years of life.

11. Small volume, convenient and flexible installation

4.Technical Specification

TYPE:EMI-LT

Applicable for : led tube light

Applicable for lamp power : 1-60W

Inner package material : high quality cold-rolled steel plate spray white and environment friendly paint

Charging power: AC85V-AC265V，50HZ/60HZ；

Emergency time:1-3hrs

Emergency power level:100%

Emergency output voltage: DC220~310V/DC220~310V (Option)

Inverter Dimension : 166*41*29mm

Emergency Conversion time:0.1sec

Charging time :24hour

Battery: To be configured with different back‐up period and different light output levels.


5.Emergency Solution:

1. According to EN60598; EN 55015; CE;

2. Deep discharge protection

3. Operation time (discharge):1hour(Customized within 1hr)

4.Lumen Factor : 100%

5.Emergency Output:DC220V

6.Matched Emergency Solution : 12V/2.0Ah Ni-CD Battery + Inverter+ Metal Box+ Inner Box


6. Dimension （mm ）:

Battery Size : C type (50*25mm/cell)

Inverter Size : 166*41*29mm


7.Application:

Product name: Emergency module for LED Tube

8.Usage range：

①Hotels
②Conference/Meeting rooms
③Factories & Offices
④Commercial Purposes
⑤Residential/Institution Buildings
⑥Schools, Colleges & Universities
⑦Hospitals
⑧Places where energy saving and high color rendering index lightings are required

9.Installation

-. L (line) and N (neutral) must be always charged, external connection with control switch is prohibited.

-. Strictly comply with the wiring diagram to connect circuit in other conditions

10.Wiring Diagram:


Attentions:

-Pay extra attention to the negative and the positive pole of the battery in order to prevent reverse operation, please use designated and matching batteries and ensure all wiring is done correctly and stable before use.

-If you need to do product testing, unplug the battery pack when the emergency device is disconnected from the mains supply, and then plug in the battery after the emergency device is completely shut down.

- Comply with the wiring connection circuit diagram completely, prevent from over loading and non loading in the process of use and testing.

-In order to prolong the battery powered lighting time, all indicator lights are switched off during normal use with the emergency power system in standby mode.

- The battery is not charged before leaving the factory; please charge the battery longer than 24 hours before use.

-In general, the battery needs to be fully charged and discharged for around 3- 5 times in order for the Ni-CD/Ni-MH battery to operate at full capacity.

8-It is detrimental for the Ni-CD/Ni-MH battery to lie idle for a long time, especially when it runs dead. Charge the battery completely when it is out of operation for a long time. (The battery cannot lie idle for more than three months)

Important:

It is recommended that the module is installed by a competent person ensuring the installation complies with the necessary standards. EVEN accepts no responsibility for injury, damage or loss, which may arise as a result of incorrect installation, operation or maintenance. the conversion requires an unswitched supply for charging the battery and a switched supply for a maintained conversion.Ensure that the finished converted luminaire operates within the module and battery temperature ratings.Ensure that the original luminaire components are still operating within their temperature ratings.

Note the production date of the battery.

-Charge the battery completely when it is out of operation over 3 month.

-Check the emergency module functionality for 3 month intervals.

-Replace the battery every 3 years interval

Shenzhen EVEN Technology Co., Ltd is the leading battery manufacturer in China, who focus on emergency Lighting Kit,LiFePO4, Li-polymer, Li-ion, NI-MH, and NI-CD rechargeable batteries, our products passed by UL, CE, ROHS and FCC certifications.

Our company has 8 years experienced in R&D about battery in mainland and 4 years export to overseas.In our ISO 9001:2008-certified factories, which span a total of 16,000 m2, we can turn out over 3,000,000Ah monthly production capacity. With professional R&D team, experienced workers and advanced equipments, we are determined to provide you high-quality battery.

EVEN has development,manufacture,selling and service department as a whole.

We own our complete production techniques and superior testing device.What we make emergency pack has its practicability and easy to install.Our IC control circuit board use from import,which make sure that use more security,higher efficiency,more energy conservation and environment protection,longer life and other more advantages.So it is popular to selling in Europe,United Kingdom,Chile,Hongkong,Asia and others countries and regions.The emergency pack from EVEN both use normal commercial power and emergency power,it will be quick and automatic when it switches.

Our batteries are widely used in electronic products which include handheld device, medical equipment, GPS, electric bicycle , emergency lighting, duplicate reading battery machine , miner"s lamp, two-ways radio , outside advertising board, UPS, solar energy system, auto starting system ect.

We take humanistic management as our concept, regarding people as the most important factor in our development.We pay attention to safety & environmental protection and take the responsibility of the society. With great passion and faithfulness, we are willing to provide our customers perfect service and striding forward with you to create a bright future.