Click on the image to view the original image
p10mm 8x8 pixels 64leds flexible mini led matrix ws2812
This 8x8 pixel WS2812B flexible LED matrix is a great way to add an impressive amount
of color while still being able to individually control each LED.
We aren’t kidding around, that’s 64 individually addressable LEDs on a 80mm x 80mm flexible panel.
You can create animations, games, or even incorporate them into a fun e-textiles project. On top of all that,
thanks to its flexible backing, this LED Matrix can be bent and bowed to fit onto almost any curvy surface.
These panels require a 5V low voltage input for power which needs to be able to source a good amount of current
– up to 2A in most uses (2A if all LEDs are set to bright white, which is NOT recommended).
Attached to each flexible LED matrix are two 3-pin JST SM connectors and two sets of bare power cables (input / output), which provide you connections for DC5V+, COM-, DAT, and GND. Needless to say, if you are looking for
a large panel of addressable LEDs to fit the contours of almost any surface you’ve come to the right place.
Note: Repeated / Over bending may significantly reduce the structural integrity of the flexible panel. It is advisable when
bending it over curved surfaces to not be too rough with this product as you may damage LED traces or the panel itself.
Needless to say, do NOT fold this matrix in half!
| LED Chip | SMD5050 RGB LED chip |
| IC Chip | WS2812B(WS2811 IC built-in 5050 RGB LED chip) |
| LED Quantity | 64LEDs/pcs |
| Input Voltage | DC5V |
| Watts | 12.2W/Max |
| IP Rate | IP20(non-waterproof) |
| PCB Color | Black PCB |
| View Angle | 140° |
| Color | Addressable full color |
| PCB Pitch | 10mm |
| PCB Size | 80mmx80mm |
| Warranty | 2 years |
| Brand | iPixel LED |
WS2812B flexible LED matrix-8x8 pixels
it's very easy to add any letters while each individually control .
that’s 64 individually addressable LEDs on a 80mm x 80mm flexible panel.
You can set any animations
These panels require a 5V low voltage input for power which needs to be able to source a good amount of current – up to 4A in most uses
(3.8A required wen you set all LEDs in white color).
there are two 3-pin JST SM connectors and two pcs bare power cables
Red :DC5V+, Yellow:COM-, Green:DAT, and Yellow GND.
when the full panel set as white color , the whole PCB getting very hot even if
we used 1 ounce Copper
you must supply power to each panel when you links many pcs
Note: please pay attention to the matrix when you bending the flexible panel
We have have size of flexible led matrix:
1. ws2812b 8 x 32 pixel led matrix 2. ws2812b 16 x 16 pixel led matrix