Click on the image to view the original image
Aluminum UL Class2 Power Supply Dimmable Triac Led Driver
Product Features:
- UL8750 Class2
- Nema 3R - Outdoor use
- Triac, 0-10V Dimmable
- Dimming 8W Minimum Load
- Super compact Aluminum Case
- Constant Voltage, Constant Current Dimming
- OCP/ OVP/ OTP/ SCP Preotections
Parameters:
| Item | 24VDC Class 2 Voltage LED Drivers |
| Input Voltage | 120V AC |
| Power Factor | 0.95 |
| Efficiency | >90% |
| Waterprrof Level | NEMA 3R |
| Approvals | UL8750 & Class2 |
| Operating Ambient Temperature | -20℃-70℃(-4℉-158℉) |
| Color | Black |
| Short circuit protection | yes |
| Overcurrent | yes |
| Over temperature | yes |
| Open circuit protection | yes |
| Input Wires (White \ Black) | 18 AWG |
| Output Wires ( Red + \ Blue - ) | 14 AWG |
| Housing Material | Aluminum |
| Dimensions L*W*H | 6.97”×2.76”×1.38” |
Driver Schematic:
| Length | 6.97 (177) |
| Width | 2.76(70) |
| Height | 1.38(35) |
12-Volt DC Installation Guide:
Highly efficient, stablized, constant voltage DC power for LED lighting
General
•This driver is to be installed in accordance with Article 450 of the National Electric Code and installed by qualified and professional electrician.
•Please make sure the driver is installed with adequate ventilation around it to allow for hear dissipation.
Before Installing
•Power must be disconnected at all times during installation.
•Observe polarity of the 12volt DC output. Failure to observe polarity could damage LED lighting.
•Total wattage of all LED fixtures used must not exceed the maximum watt rating of the power supply.
Input Connections / Grounding
•Use the clamp connectors to secure cords and wires.
•Route and secure wires so they will not be pinched or damaged.
•All wiring must be in accordance with national and local electrical codes, low voltage Class 2 circuit. For wire runs inside of walls, use properly certified CL2 or better cabling and appropriate mounting hardware. If you are unclear as to how to install and wire this product, contact a qualified electrician. Failure to install this device properly may result in electrical shock or fire.
•Do not install Class 2 low voltage wiring in the same runs as AC main power. If AC and low voltage wires across, keep them at 90-degree angles.
•The driver case MUST be grounded in accordance with the N.E.C. Connect the ground wire to the driver green wire.
Output Wire
•Bring the wires of the light fixture through the other clamp connector and connect them to the driver wires - positive to the red (+) wire and negative to the blue (-) wire.
Dimming
•Dimmable with any standard MLV/Incandescent TRIAC (Leading edge) dimmer switched.
•Dimmer switched is to be installed on the input (120VAC side) of the driver.
Are you manufacturer?
Yes, we are the manufacturer for power supply and Led drivers. We could offer Original adapters and OEM adapters.