Click on the image to view the original image
1220 mm width crossflow cooling tower fill
Our cooling tower fill include the cross flow cooling tower fill and counter flow cooling tower fill, the different type cooling tower fills can treat the water flow from 5tons to 300tons.
cooling tower fill material is a hanging film type cooling tower fill which spreads the water into a thin film, flowing over large vertical surfaces, promoting maximum exposure to air flow. Thisfill provides much more water surface exposure per cubic foot than splash type fill.
1220 mm width crossflow cooling tower fill
MX Fill is available in MX75 configuration and higher-performing MX625 configuration. MX is a hanging film type cooling tower fill which spreads the water into a thin film, flowing over large vertical surfaces, promoting maximum exposure to air flow. This type of fill provides much more water surface exposure per cubic foot than splash type fill.
MX fill incorporates highly efficient cellular drift eliminators, integrally molded within the fill sheets. Compared with previous designs, these eliminators reduce drift emissions from the tower by a factor of ten or more! Less drift means tower owners save water bills and water treatment chemical expenses.
This fill virtually eliminates the nuisance caused by drift spotting on adjacent buildings and property. For additional savings, the drift eliminators discharge air directly toward the fan. Discharge air, traveling in the right direction when it leaves the eliminators, translates to lower fan horsepower.
Louvers are also integrally molded within the fill sheets preventing water from escaping and assuring precise air distribution throughout wide variations in airflow. Unlike towers equipped with separate external louvers, this fill operates virtually ice-free even in extremely cold weather.
MX fill is thermoformed from PVC with a flame spread rating less than 25 per ASTM E-84 and is considered selfextinguishing. Therefore, the risk of fire damage is minimal.
We have many years for exported Cooling towers filling, we are professional for installation and production.
Water temperature: -35~70℃
Tensile Strength: 6,300 psi(at room temperature)
Tensile Modulus- 325,000 psi
Specific Gravity 1.50
Maximum Continuous Hot Water Temperature 52℃
PVC Sheet Thickness 0.25mm,0.40mm
Sheet Spacing 19mm
Cooling tower fills Package
width 300mm 600mm cooling tower filler
width 750mm cooling tower filler
width1330mm cooling tower filler
Width 500mm cooling tower filler