Click on the image to view the original image
New LED Grow Light Par 38 15W E26 E27 for Organic Bulb RED BLUE New Style for small plants
New product introduction
This LED grow bulb has low power consumption high luminous efficiency and long service life, the electronics inside are stepping down the voltage. The outside is constructed in aluminum seal with the good thermal structure, waterproofed and keeping your temperatures down perfectly .This growing lamps emit the wavelength of light which can be fully absorbed by the plants photosynthesis; no energy waste like fluorescent lights etc. Sources rich in red light are more efficient and beneficial for photosynthesis, best for blooming and fruit .The Chlorophyll and Carotenoid need blue much, good for the photosynthesis, best for promoting the leaf.
Specification
Model | Wattage | Dimmable | Input Voltage | Beam Angle | IP Rating | Dimension |
PAR20 | 7W | No | 100-240V 50-60Hz | 30° | IP 65 | φ63mm x 92mm |
Yes | 90-130V 180-240V 50-60Hz | |||||
PAR30 | 12W | No | 100-240V 50-60Hz | 30° | IP 65 | φ95mm x117mm |
Yes | 90-130V 180-240V 50-60Hz | |||||
PAR38 | 15W | No | 100-240V 50-60Hz | 30° | IP 65 | φ120mm x127mm |
Yes | 90-130V 180-240V 50-60Hz |
Using tips
1.Lighting Time setup: Vegetative Stage: 12-14 hours on;
2.Flowering Stage: 9-12 hours on. Fruiting Stage: 7- 8 hours on
3.Suggest distance above plants: 1.2-2m
Maintenance instructions
1.anti-static: LED is due to electrostatic slow parts, if is down LED lights with no good anti-static measures, it will burn out LED, the formation of waste. There needs to pay attention to the electric iron must use anti-static soldering, maintenance personnel must also run simultaneous anti-static measures (such as wearing anti-static gloves and electrostatic ring etc.).
2.the continuation of low temperature: two main groups of LED light belts, LED and FPC, are not able to endure low temperature goods. FPC if it is continuing low temperature or may exceed its acceptance measure, it will crack the covering film of FPC and form LED lamp belt indirectly. Simultaneous, LED has not been able to continue the tolerance of low temperature, is low temperature for a long time, and its chips will be burned at low temperatures.
3.short circuit: a lot of LED lights with no light is due to a short circuit pin, is down before must investigate the real reason not bright. Otherwise, if you change the bright LED without delay, it will continue to form when you call back again. The chip of LED will be short circuited and the electric shock will be worn. Because LED is a new change in advance, must first find the real reason not bright, with targeted ability.
Our Services
