Click on the image to view the original image
Laboratory digital Thermostatic sand bath
I. Use summary
This product be applicable toes the industry coal mine the business enterprise,science to studydthe unit etc.s to do the chemistry to analyze,physics measurement heat it use, to easy spillage the combustible heat hour most for the suitable for use .
II. Product construction:
The coldand flat plank of outer shell adoption inhibits to take steel to cast but,and proceed after antisepsis craft handle,heat constant form,Theadoption have noes the class regulate the control the exportation the power then to adapt to the demand of the different heating temperature.
III. Main Parameters:
Capacity(mm):400×280×80
Power(KW):1.8
Voltage(V):220
Temp Range(℃):RT-300
IV. Install and use:
1.Put the product on a dry flat.
Set three-phase outlet to the power,and link the grounding.
2.Temperature setting
Set temperature: press SET key to set temperature. After pressing SET key, data on lower line digital tube will flash (the upper low measure temperature normally), which means meter enters the status of temperature setting. Press up key to increase set value, and press key to decrease set value. If continuously press increase key or decrease key, set value will change rapidly. Press SET key again, and meter returns to temperature under normal working status. Setting is finished.
Correction of sensor error: When confirming that displayed value on meter is not correct, correct displayed value. Press SET key for 3 seconds to enter internal menu of meter, and press up or low key to correct this parameter after selecting parameter SC. Correction range of sensor error is +50~-50. After finishing correction, press SET key again for 3 seconds to exit. Correction value of meter when ex-work is 0. When using, one shall preventing correct meter from being corrected incorrect.
V . Matters need attention
1.Can not touch the cover when use.
2.Put the product on a dry place when long time no use.
VI. Main breakdown processing
Problem :
I . (Does not heat up)
Reson:
1.The power source plug has not inserted .
2.The heating wire or the ties break .
3.The primary device is bad .
Breakdown processing :
1.Insert the power.
2.Change the heating wire or the ties.
3.Change the primary device.
BIOBASE is a professional manufacturer of laboratory products from 1999. Our main products are Biosafety Cabinet (Class I,II,III), Laminar Flow Cabinet, Fume Hood, Biochemistry Analyzer, Referigerator, Air Shower and Incubator.
-We built an excellent research team which consists of 50 professional engineers
-We have 13 years production experience and a strong technical production team, we adopt hih-tech and state-of art production equipments from Italy, Japan, and Switzerland, etc.
-We have a strong quality control team to inspect all production stage, from the purchased accessory to the finished products.
-We have full sets of advanced quality assurance equipments.
-Certificates: ISO9001;ISO13485;ISO14001; CE; MET; NSF 49.
-We are and will continue to be supplier of the most categaries of laboratory.
Mainly wooden and carton ,special demands also can be meet.
Our principle is to provide our perfect service to you.our target goal is to offer you our excellent
service.
With the sustained business conception of “credit is the basis, quality is the first”, we gain the high trust from customers.
Our main products are main divided into 4 parts:
Medical Isolation Equipment like Biosafety Cabinet(Class I/II/III),Laminar Flow Cabinet,Fume hood;
(2)Cold-chain products like Medical Refrigerator,Deep Freezer&Ice maker;
(3)Analyzer like Biochemistry Analyzer, Elisa Reader&Washer etc.
(4)Biochemistry reagents
Any question or help,please feel free to contact with me at any time!
Contact :Psyche Liu (sales supervisor)
Email:sales57 @biobase.cc
Tel number:86-531-82373113
mobile:008615853187153
WELCOME TO CLICK AND INQUIRY.