Click on the image to view the original image
Latest COB Full Spectrum LED Grow Lighting LED Plant Lamp
Product Introduduction
1. Fashionable outlook
2. Ultra thin and convenient, the thickness is 1/4 of the traditional light thickness
3, High-density aviation aluminum material, fast heat dissipation
4.Imported LED chip, long lifespan, high brightness and low light attenuation
5. Super waterproof grade, LED source light waterproof and shell waterproof, duplicate protection
6. AntI dropping, explosion proof, high temperature resistance, the transmittance was
Notice before installation
1.please read the instructions in detail before use
2. Non professional technical personnel, please do not open or refit this product without authorization.
3. Please close the power supply before installation, so as to avoid the improper operation of electric shock.
4. Before installation, please check whether the voltage marked on the LED projection plant lamp is consistent with the input voltage to be connected, so as not to damage bad LED lights or plant lamps.
5. In order to ensure the service life of the product, please do not use in the mist gas concentrated areas
6. In the process of installation and transportation, we should pay attention to earthquake imitation
7. Before installation, ensure the installation position can bear 10 times the weight of the product, installed in no vibration, no swing, no fire hazard.
8. If the lamps and lantern fail, please send the lamps and lanterns back to the factory for inspection and maintenance.
9. If the light body wire is found to be damaged, please stop the use of power immediately.
Installation instructions
1. punching holes on the wall or ground, installing expansion screws, installing LED lights or plant lamps, locking screws and installing distance between lamps and lights according to the requirements of customers;
2.Select the irradiation range and fix the bracket behind the LED light or the plant lamp in a desired angle
3. The support behind the LED light or plant lamp is mounted on the wall or the ground which can be suspended
4. Connect the connection line. the connection line"s interface is tied with the insulating tape
5. Turn on the switch and test whether the light is normally bright