If the aluminum veneer is designed according to the curtain wall project, it must follow the reasonable design, processing method, and installation structure of the aluminum veneer. It is not allowed to change the design of the aluminum veneer randomly because of the curtain wall project. The structural design of the aluminum veneer has passed a very strict practical test. The following common-sense problems must be understood when designing a curtain wall with aluminum veneer.
Aluminum Veneer Curtain Wall Panel Produced by BANGLI
1. Aluminum veneer specification: the width of aluminum veneer must be given priority. The maximum size of the aluminum veneer is 8000mm × 1800mm, which must not be exceeded. Otherwise, it is easy to cause surface deformation and instability after installation. The width of the aluminum veneer should be 1.5m and below. The aluminum veneer with this specification can be produced quickly and the price is acceptable to many customers. Generally, the length of the aluminum veneer is generally unable to produce aluminum veneer with length more than 6m, because the production equipment of many manufacturers of the aluminum veneer is the only 6m, so it is not suitable to use.
2. Folding analysis of aluminum veneer: single-layer aluminum plate component, all around folded edge. After the folding of the aluminum veneer, it can connect the left and right sides. After the folding of the aluminum veneer, it becomes a reinforcing rib to strengthen the panel and prevent deformation. Aluminum veneer folding design to do a simple analysis, folding after the impact of various factors on the aluminum veneer.
3. Welding of veneer: most aluminum veneers adopt welding process, such as the part where the folding edge is connected, the part where there is a gap after the folding and the aluminum plate needs to be supplemented, and the welding between the reinforcing rib planting nail and the aluminum plate, etc. The welding process is generally deepened by the aluminum veneer processing plant. It should be noted by curtain wall designers that if welding is necessary for the design of aluminum veneer, the location of the weld should be considered. Aluminum veneer will deform under the influence of high temperature during welding. Although the welding seam should be smoothed and putty repaired after welding, the effect after spraying is still quite different. Therefore, it is necessary to avoid exposing the weld to the obvious position.
4. Use of aluminum veneer reinforcing rib: the concave groove of aluminum veneer, L-shaped angle aluminum or special aluminum profile can be used as the reinforcing rib, and the section size shall meet the calculation requirements. Most of the fixation methods are implant screws into the back of the aluminum plate panel and screw to fix the reinforcing rib. Implant nails are usually implanted by welding or bonding. The importance of aluminum veneer panel lies in the existence of stiffeners, which can make the aluminum veneer into various shapes, flat, and strong compression resistance.
The above four points about aluminum sheet design can help you. Bangli building materials specializes in the production of various types of aluminum veneer for more than 20 years, with advanced technology and experienced team, welcome to customize and purchase. Bangli, give you a different service experience.
