The renovation of the new house was very happy. Many friends found that the tiles on the wall were empty after the check-in, causing no small trouble. The phenomenon of tiling in the tiling is indeed common, and it is not only difficult to repair but also dangerous if it falls off. Why do new house tiles always have empty drums? That was when the master tiling did not do these 4 points.
Tiles to close one: cement mortar to be full
When some masters tiling, the cement mortar is too thin, or the back is not full enough when tiling. Finally, there is no hammering with a leather hammer. In the later stage, it is easy to appear empty.
In fact, many people now use tile adhesive to tile directly. Although the price is higher, the chance of problems is even smaller.
Tiles check two: Tiles should be evenly soaked
(must be flat, completely soaked)
When the non-full tile is soaked in water, it should be completely soaked. If the water is not evenly distributed, the water in the cement is sucked away by the tile, and the cement is too dry, which may cause it to stick, and may appear empty or even fall off.
Tile control three: wall to be handled
Wall brushing will be ignored by many people. If the wall is not pulled, the adhesion of cement is limited, and it is easy to stick to it. Therefore, we must first clean the original impurities on the wall before tiling, and then do the brushing process, after the inspection is completed, and then tiling.
Tiles check four: new and old walls to hang nets
During the renovation, some modifications will be made to the wall. After the transformation of the new wall and the old wall, it is necessary to hang the net and hang the brick after hanging the net to avoid different water absorption rates of different materials.
