Solar street lights are installed in several major steps: digging pits, assembling lights, and installing poles. However, every step is a small project. Sometimes it may not be known where to start. For example, if you are going to dig a foundation pit, you have to consider how big and how deep the pit is. The installation will be much smoother if there is a scientific sequence when assembling the luminaries. Some ignored small details may cause the malfunction of led solar lights. Keep these installation specifications in mind will make the installation of the street lights nice and easy.
2. Observe if there are cables, wires, optical cables, etc. that obstruct the installation and use of solar led street lights. Observe the surrounding area to see if there are trees, buildings or other obstructions that affect the installation of the light.
2. Determine the installation position according to the point map. According to the base map and the construction drawing, draw the plane size of the foundation pit at the determined position
3. After the foundation pit is dug, measure the length, width, and depth of the pit with a tape measure to make sure the pit fulfills the requirements of the drawings.
Attention: Uniformity and protection of the environment is required
3.1 Uniformity: The stacking of muck should be unified. The muck should not be stacked or scattered at will.
3.2 Protection of the environment : The muck is not allowed to be placed directly on the lawn or other green areas, the site must be cleaned up after construction.
2. Ensure the foundation pit and the road direction are paralleled, and make sure the positioning plate is paralleled to the foundation pit.
3. Ensure the positioning plate is in a horizontal line . And make sure the exposed surface of the foundation is smooth.
Clean up
1. Clean up the excess concrete debris in time.
2. Clean up the concrete slag at the bottom of the battery compartment in time. (for colloidal battery solar street lights)
3. Clean up the concrete on the positioning plate and the bottom bolt in time.
Not allowed
1. The foundation pit is not allowed to dig until the size is perfectly correct.
2. Concrete is not allowed to be placed directly on the ground.
3. It is not allowed to proceed to the next installation until the clean up is finished and the dimensions meet the requirements.
2. Placing a variety of materials in an orderly way. Make it easy to fetch and use.
3. Make sure the street lamps, lighting poles and battery components, etc. are assembled correctly and wires are connected correctly.
4.Ensure that the bolts between the mating parts are tightened
5. Ensure that component wiring detection, power supply separation detection, battery connection detection, and light source detection are detected well.
6. Pay attention to safety when stalling poles, including personnel safety, item safety, and safety of surrounding people, buildings and cables.
7. Debugging after installation, to ensure that the installation is correct.
8. Make sure the working site is cleaned up after the installation. The staff should not leave until the working site is restored to its original appearance.
The above is the solar led street lamp installation specification. Hope this article brings convenience to your installation of street lights. For more tips, please feel free to contact us.