SCT DIGITAL TECHNOLOGY CO.LTD always provides customers with reasonable and efficient one-stop solutions based on the professional attitude. The smart whiteboard produced by SCT DIGITAL TECHNOLOGY has a wide range of applications. In the production of electric equipment, SCT DIGITAL TECHNOLOGY introduces advanced production equipment to enhance efficiency. Besides, we adopt advanced manufacture technique to effectively guarantee product quality. We improve the accuracy and stability of the equipment which lowers the malfunction rate. Compared with the general electric equipment, DLP Optronic Product are more solid and durable. If you are interested in our products, please feel free to contact us. The digital dry erase board is one of the main products of SCT DIGITAL TECHNOLOGY.
How to solve the condensate of the piston compressor casing? Adjust the throttle valve to reduce the amount of liquid supply or increase the return temperature. The working principle of the air compressor briefly describes that the screw single-stage compressed air compressor is turned by a pair of Yin and Yang rotors (or screws) that are parallel to each other in the cylinder, so that the air between the rotor slots constantly generate periodic volume changes, the air is transported along the rotor axis from the suction side to the output side, realizing the whole process of suction, compression and exhaust of the Screw Air Compressor. The air inlet and outlet of the air compressor are located at both ends of the housing respectively, and the slot of the negative rotor and the tooth of the positive rotor are driven and rotated by the main motor. The compressor is directly driven by the motor, so that the crankshaft generates rotating motion, and the connecting rod drives the piston to generate reciprocating
Deep hole processing Yes,It's no problem to drill 80 deep,But the premise is that you have to go back and drill back,No,Drill 40mm,The effective length of the drill must be greater than 40mm,Otherwise, iron filings will not come out,The drill bit will be held off.Yes,The general drill blade part is the same size as the C part,But the work is in front,The back is the chip chute,So when you drill deep,To drill back for a while,
