Brand：	none
Address：	China
Min.Order：	none
Supply：	none
Valid until：	Long Term

Product Details

Specification

1206 IR 940nm LED

AEO1206F-2020IR94

All-Brite 1206 is an infrared emitting diode in miniature SMD package
which is molded in a water clear plastic with spherical top view lens.
The device is spectrally matched with silicon photodiode and phototransistor

Product Description

Features

•Small double-end package

•Low forward voltage
•Good spectral matching to Si photo detector
•Package in 12mm tape on 7〞diameter reel.
•Pb free
•The product itself will remain within RoHS compliant version.

Applications

•PCB mounted infrared sensor

•Infrared emitting for miniature light barrier
•Floppy disk drive
•Optoelectronic switch
•Smoke detector

Absolute Maximum Ratings (Ta=25℃)

Electro-Optical Characteristics (Ta=25℃)

Package Dimension

Precautions for Use

1. Over-current-proof

Customer must apply resistors for protection; otherwise slight voltage shift will cause big current change (Burn out will happen).

2. Storage

2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package: The LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 After opening the package: The LED‘s floor life is 168 Hrs under 30℃ or less and 60% RH or less.
If unused LEDs remain, it should be stored in moisture proof packages.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the storage time baking treatment should be performed using the following conditions.
Baking treatment: 60±5℃ for 24 hours.

3. Soldering Condition

3.1 Reflow soldering should not be done more than two times.
3.2 When soldering, do not put stress on the LEDs during heating.
3.3 After soldering, do not warp the circuit board.

4. Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal.
Be careful because the damage of the product is often started at the time of the hand solder.

5. Repairing

Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.