Hydraulic Press

1. Hydraulic pump and hydrailic cyliner are separated  for easy replacement

2. Max. Force:  30 T  

3. Manual operation

Max. Working Pressure

1.Displayed Pressure Value to Actual Applied Force Conversion: 1 MPa = 0.6 Ton

2.The actual force applied on the Hydraulic Cylinder (Ton) equal to the force applied on your working piece

3.For calculating the actual pressure (MPa) applied on your working piece, please follow the equations in below:

          P = T/(πr^2) x g x 10

P: Pressure (MPa) applied on your working piece

T: Force (Ton) applied on the Hydraulic Cylinder 

g: Standard gravity. g ≈ 9.8 m/s2

π: ~3.14

r: Radius (cm) of the working piece

*1 Metric Ton = 1000 kg; 1 MPa ≈ 10 kgf/cm2 

Pressure Gauge

· Measuring Accuracy is  +/-1.25 kN

Heated Platen Area

1. Platen Area:   300 mm x 300 mm  ( Nominal 12"x12" )

2. Material:         Headen Cr12MoV alloy

3. Surface:         Flattening with CNC grinding 

Max. Travel Distance 

1. 80 mm 

2. Do not raise the bottom cylinder (piston) more than it's maximum traveling distance. (80 mm)

Max. Working Temperature

1. 450°C continuous with water cooling

2. 500°C for less 30 minutes

Heating Rate

· ≤ 2°C/min

Water Cooling Jacket

1. Two water cooling jacket are built on the back of top and bottom heating plate separately with 1/4" water pipe connectors. Such a configuration allows you cool the sample as soon as the hot pressing process is completed. 

2. Please consider using one recirculating water chiller to save water and protect the environment (order separately by click picture below)

Temperature Control

1. Two digital controllers are installed in one box with 30 segments programmable and auto-tune faction

2. Temperature accuracy ±2°C.

Power Requirement

1. 208 - 240 VAC, 50/60Hz, single phase

2. 3.5 kW max.

3. 20 A circuit breaker is required for 220 V,  5' length power cable included, but no plug

Compliance

· CE Certified 

    Shipping Weight

150 lbs

      Warranty

· One year limited standard warranty (Extended warranty is available up to 5 years at extra cost)

Application Note

· The Hot Press Can be located inside of a glove box which temperature controller and pump will be put outside of glove box