Brand：	none
Address：	China
Min.Order：	none
Supply：	none
Valid until：	Long Term

Product Details

Product Description

8x8 Led Dot Matrix Display Module Kit For Arduinos With Dupont Cable

Wiring instructions:
1. The module left side as an input port and the output port on the right
2. To control a single module, just connect the input port to the CPU
3. When cascading multiple modules, the input port of the first module connect to the CPU, the output port connect to the input port of the second one, and so on.

Pruduct Name	8x8 Led Dot Matrix Display Module Kit For Arduinos With Dupont Cable
Display Type	8x8 Matrix
Wavelength	625 ~ 630nm
Forward Voltage	2.1V ~ 2.5V
Forward Current	20mA
Emitted Colour	Red
Analog Input Pins	28
Emitted Size	3mm
Material	PCB + Plastic
Certificated	ROHS

Note:
1. VCC and GND is not reversed, it would burn the chip!
2. When the 51 microcontroller P0 port controlling, must be connected to the pull-up resistor, it is recommended that the resistance of 4.7K--10K
3. Please install lattice into the round hole first, and then insert the round hole to PCB board and weld. Face the side of lattice with words, from left to right pin order is 123456. PCB board 1st pin is square pad!
4.Electrolytic capacitors long-pin as positive, short-pin as negative; ceramic capacitor hsa no positive and negative points

Detailed Images