Asenware conventional alarm system fire break glass

Specification of  Asenware conventional alarm system fire break glass

Show Of Asenware conventional alarm system fire break glass 

       Asenware conventional alarm system fire break glass features:

                              1.Executive standard: GB19880-2005
                              2.Operating voltage: 24V (pulse modulation)
                              3.Operating current: <300uA (in the monitoring status); <2mA (in the action status)
                              4.Output contact: Normally open contact; capacity: 0.1A/30VDC
                              5. Weight: About 120g
                              6. Wiring method: nonpolar two-bus system (L1, L2)
                              7. Operating environment: Indoor, temperature: -10°C~+50°C; relative humidity: ≤95% (40°C±2°C,

                                   without condensation)
                              8. Coding method: It can realize online coding with the help of a coder and without the necessity of

                                  disassembling the bus (however, the equipment must be powered off). Address codes 1 to 324

                                  are available for selection.
                              9. Telephone jack: Two-wire fire telephone jack (equipped with a standard 6.3 single-track audio connector).
                            10.Starting part: A plastic pressing sheet that may be used repeatedly. It can be manually reset with a special

                                  tool after being pressed.
                            11. Starting mode: Press the pressing sheet manually.
                            12. Indicator: The red ALARM indicator will blink in the inspection status or remain lit in the alarm status;

                                   the PHONE indicator will blink when a fire telephone loop is connected, otherwise it will be out.
                                   Matched host machine: fire alarm control panel (such as AW-AFP2188)