IMPORTANT SAFEGUARDS

To reduce the risk of fire, electric shock, or injury when using any electric appliance, precautions should be made.

These precautions include but are not limited to: Read all instructions.

Carefully position in such a way that pets and children cannot stare directly at the laser.

Do Not attempt to open the protective housing or operate the device if the aperture windows are damaged. If the unit requires service that involves removing the protective housing, contact the manufacturer.

Opening the protective housing voids the warranty.

CAUTION!

Use only as directed. Do not look directly at the laser. Improper use may result in damage to the eyes due to direct exposure to laser radiation.

You may plug this device directly into an indoor power socket OR if an extension lead is required, it must be of a type suitable for outdoor use. Any outdoor connection must be completely dry before use and should be protected by a proprietary outdoor waterproof enclosure.

Residual Current Device (R C D) protection is recommended to be used on the circuits or outlets while operating this laser light outdoors or in a wet location. Receptacles with built-in RCD protection are available for this purpose.

GENERAL INFORMATION

The thermal hazard power is lower the Accessible Emission Limit of Class 3. Therefore, the laser product is Class 3 under fault condition

Avoid direct viewing of a CLASS 3 laser energy. For reference the FLPPS requirements for demonstration laser products like laser pointers are limited to CLASS 3 levels of laser energy, this product uses diffractive optics to scatter the beam energy, this scattering effect causes the energy concentration to drop below the exposure limits for momentary or  accidental viewing at relatively short distance from the laser aperture. As similar with all bright light sources, when you operate this device in unsupervised general public areas, it is recommended that up close access to the laser lights be restricted or prevented.

This laser display device incorporates a CLASS 3 laser system which by itself, may be hazardous. However, this laser display device incorporates a protective housing and diffractive holographic optics in the machine design such that there is no exposure or human access to laser radiation during operation or maintenance above the CLASS3  limits. Each individual laser beam power is under 5mW which is less than a standard laser pointer.

Package included:

1 x Laser projector

1 x AC adapter(IP44)

1 x Ground stake

1 x Mounting Connector

1 x Anchor screw

1 x Manual

1 x Remote Control

THE REMOTE CONTROLLER

ON/OFF:  To turn the device  on & off.

COLOUR:  color change; Red, Green, Red & Green

BLINK:  This mode makes each available laser color blink.

Speed:  Controls the speed at which the laser rotates (Slow, Medium, fast).

4H: Turns the laser off after 4 hours of use.

6H: Turns the laser off after 6 hours of use.

8H: Turns the laser off after 8 hours of use.

Timer Reset: Turns on the timer function. Press before selecting the required time limit. Default working time is 6 hours.