CM-HT12/F Illumination Vane can be used as a sign in all kinds of airport to observe the wind power and

wind direction in both daytime and night.

        On the top installed one red LED obstruction light, provide the obstacle hint for the pilot at night.
        On the upper of the pole installed a light stainless wind sleeve frame and one 360°rotation gear.

        Inside of the wind sleeve frame installed one waterproof LED spotlight, it will turn with the wind sleeve,

could light the wind sleeve directly, not like the old outside flood light, then eliminate the power consumption

and against the eye flare.

        On the wind sleeve frame installed one wind sleeve which is made of corrosion-resistant and

high-temperature-resistant nylon anti-UV material, and lifetime is long. The color is red(orange) and white,

have 5 sections, the start color is red(orange). The wind sleeve including 3 dimensions according to the

pole’s height.

       1#The diameter is 300mm, the diameter at small end is 150mm and the length is 1.2m
       2#The diameter is 600mm, the diameter at small end is 300mm and the length is 2.4m
       3#The diameter is 900mm, the diameter at small end is 450mm and the length is 3.6m

How to choose the wind sleeve? Below 4m, use the first type;  between 4m to 6m, use the sencond type;

above 6m, use the third type.

       On the bottom of the pole, it has a control box, you could choose the wind vany with the photoswitch; 

the power supply cable into the control box directly.

       The pole and the base all use the SUS304 stainless. The windsock height could be 2m,3m,4m,5m,6m

or as buyer’s requirement; when the total height more than 9m, you could add the stay wire in order to

increase the stability; when the windsock height more than 4m, you could choose the hinges base so that

could install more steady.