Coventional Fire Alarm Control Panel Introduction

1.AW-CFP2166 series conventional fire alarm control panel is designed based on EN54 part 2&4 standard.

2.It is modularized design, the panel can expend from 1 zone to 32 zones easily.

3.It has 2 level control mode by a lock

4.It has 24VDC and 5VDC power supply output.

5.It has FIRE and FAULT signal output.

6.It has 2 general sounders output.

7.Each zone has 1 circuit detectors input .

8.Each zone can be disable by a button.

9.It has reset button to reset the panel.

10. It has SILENCE button to stop BUZZER and SOUNDERS.

11.It has EVACUATE button to start a manual fire alarm immediately.

12.It has battery low protection function, when battery voltage lower than 21VDC, battery will be cut off automatically until the mains power is on.

13.It has an optional GSM module for fire alarm by SMS .

14.It is economic, user-friendly and easy maintenance.

ITEM

1Zone panel

2Zone panel

4-8Zone panel

4-32 Zone panel

Model No.

AW-CFP2166-01

AW-CFP2166-02

AW-CFP2166-04-8

AW-CFP2166-04-32

Power specification

Mains supply voltage

110VAC or 240VAC

Internal power supply

27.2VDC

Total output current limited

500mA @240VAC

500mA @240VAC

3A @ 240VAC

3A @ 240VAC

Main supply monitor for fault

Yes

Battery protection for low voltage

Yes

Batteries (default configuration)

12V2AH*2

Detector circuit specification

Number of circuit

1

2

4-8

4-32

Line fault monitor for open circuit

Yes

Line fault monitor for short circuit

Yes

Line fault monitor for detector removal

Yes, if End of Line Monitor Unit fitted in place of End of Line Resistor

End of Line device

6.8k Ω,5% tolerance, 0.25W (colour code-blue,grey,red,gold)

Detector continuity diodes

Silicon 1N4001 or Schottky type (required if End of Line Monitor Unit fitted to give Detector Removal Fault)

Call point resistor value

470 to 680 Ω, 0.225 or 0.5 watt

Maximum number of smoke/heat detectors per zone

20 (based on a total detector current of 2mA, each detector consuming 100μA).Note: if End of Line Monitor Unit is fitted, for correct operation maxmum voltage drop must not exceed 12 volts.

Maximum number of manual call points per zone

No limit

Sounder circuit specification

Number of general circuits

2

End of line resistor value

6.8k Ω,5% tolerance, 0.25W (colour code-blue,grey,red,gold)

Line fault monitor for open circuit

Yes

Line fault monitor for short circuit

Yes

Outputs fused AT

400mA

Maximum number of bells @ 20mA of each sounder output

20

Fuses

27VDC fuse

3A F 20mm

Fire and fault output

Output type

Dry relay output :NC and NO relay; wet source output

Maximum current

100mA

Connection block

Largest acceptable conductor size

2.5mm²

Smallest acceptable conductor size

0.75mm²

Size and weight

Dimensions(mm)

272*200*70mm

320*231*90mm

395X502X124

362X565X124

Weight (without batteries)

4kg

5kg

7kg

8kg

Weight (with batteries)

5.8kg

6.8kg

9.6kg

12.5kg

1.Conventional  fire alarm panel free technical support 

2.Conventional fire alarm panel after sale service

3.Conventional fire alarm panel OEM/ODM

4.Conventional fire alarm panel 1 year warranty