Fire Alarm System Addressable Manual Call Point

Fire Alarm System Addressable Manual Call Point Introduction:

The  AW -AMC2188  addressable  manual  call  point is mainly designed to be used with an intelligent two-bus  control panel.  If it is pressed after a fire is manually confirmed, an alarm signal may be sent to a fire alarm control panel  which will, after receiving the alarm signal, display the coded address and the equipment status of the manual call point. When the  manual call point  is operating normally, the red indicator will blink; when there is a fire alarm, it will  remain lit.  The addressable manual  call  point  supports  electronic  coding  and  has  a  built-in  fire  telephone  jack and  a PHONE indicator, making its engineering application convenient.

Fire Alarm System Addressable Manual Call Point Features:

It can realize complete electronic coding and  in situ rewriting  with help of a
coder.
Designed  with  an  upper  cover  and  a  lower  cover,  it  can  be  installed,
debugged and maintained conveniently.
It  is  designed with  a  two - wire  fire  telephone  jack  and is  therefore more
applicable to engineering application.
Designed  with  passive  output  contacts,  it  can  control  other  external
equipment directly through an intermediate relay .
The pressing sheet on the  manual call point will not get crushed after it is
pressed, but can be reset by a special tool, so it  can be used repeatedly.

Fire Alarm System Addressable Manual Call Point Parameters:

1.  Executive standard: GB19880-2005
2.  Operating voltage: 24V (pulse modulation)
3.  Operating current:  4.  Output contact: Normally open contact; capacity: 0.1A/30VDC
5.  Weight: About 120g
6.  Wiring method: nonpolar two-bus system (L1, L2)
7.  Operating environment: Indoor, temperature:  -10°C~+50°C; relative humidity:  ≤95% (40°C±2°C, without condensation)
8.  Coding  method:  It  can  realize  online  coding  with  the  help  of  a  coder  and  without  the  necessity  of
disassembling the bus (however, the equipment must be powered off). Address codes 1 to  324 are available
for selection.
9.  Telephone jack: Two- wire fire telephone jack (equipped with a standard  Diameter6.3 single-track audio connector).
10.  Starting part: A plastic pressing sheet that may be  used repeatedly. It can be  manually reset with a special
tool after being pressed.
11.  Starting mode: Press the pressing sheet manually.
12.  Indicator: The red  ALARM  indicator will blink in the inspection status or remain lit in the alarm status; the
PHONE indicator will blink when a fire telephone loop is connected, otherwise  it will be out.
13.  Matched host machine: fire alarm control panel (such as AW-AFP2188)

                                           Fire Alarm System  Addressable manual call point

Welcom to contact me!

My Skype:asenware.sales.5