1.Fire LED Display Panel

2.Fire Display Panel Introduction:

Fire display panel is a kind of microprocessor -controlled fire display panel developed by our company. Each display panel is connected to a fire alarm control panel produced by our company via a special RS-485 interface to process and display the data sent from the fire alarm control panel. Each floor of a building may have a firm display panel installed. When there is a fire alarm on the floor where the display panel is installed, or the neighboring floor above or below it, the display panel will give a  horn/strobe  alarm and display the  floor No., the room No.,  and some other position information of the fire alarm.

3.Fire Display Panel Parameters:

1.  Executive standard:  General Technical  Conditions for Fire Indicating Panels  (GB17429-1998)
2.  Display capacity: Each display panel can display the fire alarm  messages  of floors  -10~90 and at most 99 fire alarm messages or feedback messages.
3.  Wiring system:  Four-wire system, power lines (+24V, GND) and RS485 signal lines (485A, 485B)
4.  Operating environment: Indoor; temperature:  -10°C~+50°C; relative humidity:  ≤95% (40°C, without condensation)
5.  Power supply: DC 24V  ±20 %
6.  Overall power consumption:  <3W
7.  Contact  capacity:  Relay  dry  contacts,  normally  open  or  normally  closed,  capacity: 1.25A/DC30V (resistive load)