Led Edit Software 2048 Pixel SD Card T1000s Controller for Led Digital Strip

ST4K Character:
a. wireless synchronize, control area 500 meters
b. with 4 output ports, each port can load 1024 pixels.
c. digital tube show the controller status.
d. program saved in SD card, maximum 15 files.
e. can adjust the play mode, speed etc.
f. over voltage protection.
g. support DMX512 protocol or others drive IC.

 Panel function:

1.Digital tube display.                               6.Antenna port. 
2.Single mode / select program.               7.SD card                       
3.Cycle mode.                                          8.Power 1: DC 5-24V;
4.Add speed(1-30).                                  9.Power 2: DC5-24V; (use one of power)
5.Reduce speed(30-1).                          10.Output signal port.

NOTE 1: “2”+“4”brightness add(1-10), “2”+“5”brightness reduce(10-1).

NOTE 2: switch of power, keeping press“3”and switch on power, the controller will

change mode.There are 3 mode, sender, receiver, and repeater.

NOTE 3; switch of power, keeping press“2”and switch on power, the controller will

reset: Speed 20,brightness 10, sender mode.

 1:Number of program.(1,2,3,4,5,6,7,8,9,0,A,B,C,D,E,F)

2:Blinking indicator read SD card.
3:“ ”means single mode,“ ”means cycle mode.
5,7:Show plays speed.

remote control settings:

1.the playback speed +                                                2.Single / cycle

3.Play deceleration                                                       4.Play the file plus

5. brightness plus                                                          6. Clock plus

7. Less Brightness                                                        8. Clock Less