T-1000S System features

1, 32—256 Gray level,Support software Gamma correction.

2,Support the rules and special-shaped handle.

3,Single-port output,can support 2048 pixels.

4,Off-line(SD Card) control, play back content stored in the SD card.

5,T-1000S store a maximum of 16 programs,copy multiple files to the SD card in order,after formatting the SD card as “FAT” format.

6,The program must be named in orders . just as :00_1.led, 01_1.led, 02_1.led.

7,Compatible with single line or double line chips

3. The meaning of flag :

 TTL signal(245/spi signal):               RS485 signal.

NOTE:

For the TTL(SPI) signal, the controller signal ground must connect to the LED ground wire directly.    

  Mode of connection

1.         Multiple T-1000S controllers can be cascaded together and work synchronously.

2.         T-1000S one TTL(SPI) signal and one RS485 signal port output,can control 2048 pixels/lamps;

3.         When the chip for LED is single line chip just with data, then just need to be connected with DAT and GND of the controller. If the chip for LED is double line chip with DAT and CLK, then need to be connected with DAT, CLK, and GND of the controller.

4.         If you need to use RS485 signal you need to connect controller A interface with LED lamps A (DMX+), controller B interface with LED lamps B(DMX-),

5.         If you need to control a new IC type by the controller, software code mode is:T-1000-IC model.

 Question 1:After power,the T-1000S ERROR indicator has been flashing without display output

answer:The ERROR indicator has been flashing means the controller did not read the card correctly, possible problems:  

1. SD card is empty, with no effect file.    

2.The effect file in the SD card and the controller model are not match, please choose correct controller model in LedEdit and then re-create the effect file *led.     

3.SD card did not format to FAT before copy effect files.     

4. Please check the supply power voltage, the controller can be individually powered to exclude power reasons     

5Changing the SD card and then test to exclude the possibility of a bad SD card

Question 2: The controller is powered on, the indicator is normal, but the lamps have no effect change

Answer: The reasons for this are as follows:

1 Check if the lamp′s signal line and the controller connected correctly

2  If the TTL signal is received, the lamp and the controller must be common ground, that means connect the lamp′s and the controller′s ground wire together

3  Check if the model chose during making display files on the SD card match the chips used in the lighting

Question 3:Controller and light connected, after. Lamps flicker. Controller indicator to normal.

Answer:

1 The ground wire is not connected between the controller and lighting.                  

2 The file in SD card is bad, Chip model does not match with the actual.                  

3 Insufficient power supply.

Question4: The SD card can not be formatted.

Answer:

1 First make sure the SD card on the side of the protection switch is already open.        

2 SD card reader is broken                  

3 Do all of this can’t deal with the question. Change the SD card tests again.

 More question about controller , please contact me no hesitate .