- Control IC included, supporting numerous Color-change effects;
- Pcontrol by SD controller,Arduino,DMX512,Artnet;
- Flexible PCB 5V low voltage input;
- PCB Color: White;
- Absolutely addressable ,each IC built inside RGB LED;
- 5M per roll,also Customer’s length available

You can see from this picture, it with very narrow PCB width, just 4mm.

the have 3 point each weld pad, DC5V+, GND, DAT

and it's addressable, and you can cut each LED by yourself.

you can check the back side from this picture, we will stick the 3M adhesive on back side, you can stick the strip by yourself, very convenient

and the both end covered the heat shrink tube

Yes use 3PIN JST female and male connectors

SPI signal: LED Strip+LED power supply +LED controller

DMX control: LED Strip+LED pwer supply+DMX Controller+DMX decoder

LED controller: T- series SD card controller, RF remote controller, DMX controller, Arduino.

(offline / PC online)

LED power suppply: power supply, T- series, A- series power supply...(waterproof / non-waterproof)