1. 1.      Main parameter

Solar panel parameter (25℃ standard candles)
Over size	266mm ×262mm×5mm
Power consumption	11W
Operating voltage	4V
Open-circuit voltage	4.72V
Operating current	2.75
Short-circuit current	3.03A
Withstand level	1000V
Structure type	Stainless frame, tempered glass sealed
Lifespan	20years

1. 1.      Installation:

This type of light is whole-construction. When installation, use the 4pcs of matched screws (M10) to tie the lights to the steel frame. Make sure screws are tightly tied.

It is necessary to pay attention to the direction of the solar panel. When the lights are use in the Northern Hemisphere, the panel faces to south. When the lights are use in the Southern Hemisphere, the panel faces to north. Then it can make good use of the solar panel. Meanwhile, around and above of the solar panel installation location must haven’t any obstructions, so as not to affect the energy absorption of the solar panel.

On the side of the lamp base, you can see a red button switch(Operation switch), press the red button down, the light will flash for a short time, after about 5 seconds, the green LED will be on (it means the lamp has begun work normal). When you need to close the lights, turn the red button back, after about five seconds, the green LED will be off (it means the lamp is closed). In order to keep the battery have a longer stock time, pls make sure the red button switch is off and the light is closed during storage time. Only when you installed the light then open the red button switch.

            The switch Off                               The switch on

1. 2.      Test :

If the test is taking in the daytime, pls use the opaque materials which square is more than the solar power panel to cover the solar power panel; if test is taking under the sunshine, it even need to cover the bottom of the solar power battery, make sure no lights can shine to the solar power battery, after 10 seconds, the lights start flash working; but when the light put into use, pls don’t cover it.