Desription

The“F” series is widely used for all of fluorescent lamps including T5/T8/PL/CFL/2D and so on. The emergency inverter provide high power and high voltage current to the lamp directly without assorting with ballast or starter in case of mains off, Emergency power can be set up 4W to 8W while emergency duration can be customized freely.

Properties

• 1or 3 h rated duration

• Compatible with all electronic ballasts

• Can also be used in combination with conventional magnetic ballasts

• Optimised AC output voltage for TC-DD and TC-L lamps

• Optimised DC output voltage for T8 lamps

• Cathode heating adapted for compact lamps

• Switchover relay with high-current contacts

• Green charge status display LED

• Test switch Emergency  

• Emergency lighting supply unit for manual testing

• For linear and compact fluorescent lamps

Sanforce is a manufacturer specializing in emergency conversion kits for LED and fluorescent lighting since 2008.
We cooperate with valuable supply chain, inspect all the incoming materials and set up strict product assurance system, such as SMT, Auto Aging test, Simulation test during our production process. We have very skillful and responsible workers, most of them have been working here over 6 years.
With strong technical support and customer- oriented service, you can be sure that Sanforce is ready to support you, whatever your needs.

1.Can fluorescent emergency kit be used for LED light?

NO
The emergency output is high voltage and high frequency (1000v 230KZ))for fluorescent, That
is not applicable for LED system.

2.What is the difference between high temperature battery and normal temperature battery?

The main difference is that high temperature battery can be trickle charged well even
though the emergency power kit stay at high temperature due to insufficient radiating
caused by the lights working for long time, while normal temperature battery may stop
charging in such conditions that result in emergency light failed to work. We would highly
recommend to use high temperature battery for emergency lighting kit.

3.Does battery have an end-of-charge detection/over voltage protection?

No, The battery is being charged all the time, The charging current will be decreased based
on the capacity status during the charging process. For NiCD and NiMH battery, it is
applicable for constantly charging without any risk even though no over voltage
protection. But under voltage protection is set up for discharging.

4.You have the ability to do independent research and development?

Our engineering department has 3-5 people, we have the research and development
capabilities. We also collect each customer’s feedback regularly, We have the ability on
product improvement and new product development.

5.Why is the fluorescent tube blackened once activate with emergency kit?

The reason is that our emergency output is one way of high frequency pulse,the output of
pulse waveform is not completed but only half of that .But itwill not affect the
functionality of fluorescent tube because of the emergencyrunning is not frequent. Unless
emergency back up functionality is neededall the time that will impact the life of tube
slightly.